- Rout rabbet in the back (wall side) of solid surface countertop (1/8″ deep and 7/8″ wide).
- Cut Cove Stick (15/16″ wide and 1/2″ thick).
- Cut Cove Splash (3-11/16″ wide and 1/2″ thick). One side must be machined.
- Glue Cove Stick to the Cove Splash using Pinske Cove Jig (#91144N).
- Allow to dry until adhesive is cured.
- Take the glued piece and run it through the Cove Shaper (#91510)
- Apply 1/2″ x 1/2″ Scribe Stick to the backside of the Backsplash piece. Allow glue to cure.
- Clean off 1/16″ this cleans the glue off the Scribe (your height should now be 3-5/8″).
- Pre-sand the face of the Backsplash piece and the top edge of the Scribe.
- Glue the Cove Backsplash piece into the rabbet using Pinske Edge Adjustable Wood Clamps (#233) and J&L Clamps (#207).
- Remove excess glue and finish sand.
Leave a Comment
You must be logged in to post a comment.